Sökning: "spacings"
Visar resultat 6 - 10 av 25 avhandlingar innehållade ordet spacings.
6. Eutectic Modification of Al-Si casting alloys
Sammanfattning : Aluminum alloys with silicon as the major alloying element are the most widely used aluminum casting alloys. The eutectic phase in these alloys is formed by hard and brittle silicon plates in an aluminum matrix. Such silicon plates can act as crack propagation paths deteriorating the toughness of the material. LÄS MER
7. Aqueous Block Copolymer Systems. Self-association, Phase Behaviour and Partitioning of Biomolecules
Sammanfattning : The phase and partitioning behaviour of aqueous block copolymer systems has been studied. The block copolymers used in this work were built up of three blocks. The middle block was poly(propylene oxide) (PPO) and hydrophobic. The two outer blocks constisted of poly(ethylene oxide) (PEO) chains and less hydrophobic. LÄS MER
8. Fuel-Efficient Distributed Control for Heavy Duty Vehicle Platooning
Sammanfattning : Freight transport demand has escalated and will continue to do so as economiesgrow. As the traffic intensity increases, the drivers are faced with increasinglycomplex tasks and traffic safety is a growing issue. Simultaneously, fossil fuel usageis escalating. Heavy duty vehicle (HDV) platooning is a plausible solution to theseissues. LÄS MER
9. On the microstructure and mechanical properties of Mg-Al alloys
Sammanfattning : The microstructural features and the mechanical properties of binary Mg-Al alloys have been investigated by using a gradient solidification technique. Homogeneous and nearly defect-free samples were produced under well controlled cooling conditions, through which the microstructural characteristics as well as the relationships between microstructure and mechanical properties in Mg-AI alloys were precisely defined. LÄS MER
10. Large Eddy Simulation of Impinging Jets
Sammanfattning : This thesis deals with Large Eddy Simulation (LES) of impinging air jets. The impinging jet configuration features heated circular jets impinging onto a flat plate. The problem addressed here is of generic nature, with applications in many engineering devices, such as cooling of components in gas turbines, in cars and electronic devices. LÄS MER