Sökning: "Angled"
Visar resultat 1 - 5 av 18 avhandlingar innehållade ordet Angled.
1. Performance of Compact Heat Exchanger in Non-Perpendicular Cooling Airflows
Sammanfattning : During recent years the main focus in the vehicle industry has been on cutting the fuel consumption and emissions as well as improving the vehicle performance. To be able to meet these demands additional systems are being introduced into the vehicle. LÄS MER
2. Physical load in computerized office work : with special reference to work tasks and equipment
Sammanfattning : The main purpose of the studies presented in this thesis wasto measure and quantify shoulder load in computerised officework. Shoulder load was studied during a whole working day andin different work tasks. Shoulder and arm load during keyboardwork and with different modes of physical computer interactionwas also studied. LÄS MER
3. A study of mold flux entrapment and gas entrainment in an ingot casting process
Sammanfattning : The focus of this work is to study the gas entrainment and mold flux entrapments during the ingot filling process based on physical and numerical modelling.The formation of the free surface was investigated in the uphill teeming method, which illustrates a dynamic change at a quasi-steady state. LÄS MER
4. Measurement and evaluation of near-field spray kinematics for nozzles with asymmetrical inlet geometries
Sammanfattning : In diesel engines, fuel injection parameters have a commanding effect on mixing and combustion quality. This research aims to enhance the fundamental knowledge of fuel sprays and their primary break-up. In addition, this research provides statistical data to validate simulation models and improve the prediction accuracy in mixing and combustion. LÄS MER
5. Design and application of experimental methods for steel sheet shearing
Sammanfattning : Shearing is the process where sheet metal is mechanically cut between two tools. Various shearing technologies are commonly used in the sheet metal industry, for example, in cut to length lines, slitting lines, end cropping etc. LÄS MER