Sökning: "Materialteknik"
Visar resultat 36 - 40 av 2768 avhandlingar innehållade ordet Materialteknik.
36. Wear mechanisms in sheet metal forming : Effects of tool microstructure, adhesion and temperature
Sammanfattning : The general trend in the car body manufacturing industry is towards low-series production and reduction of press lubricants and car weight. The limited use of lubricants, in combination with the introduction of high and ultrahigh-strength sheet materials, continuously increases the demands on the forming tools. LÄS MER
37. Very high cycle fatigue of high performance steels
Sammanfattning : Many engineering components reach a finite fatigue life well above 109 load cycles. Some examples of such components are found in airplanes, automobiles or high speed trains. For some materials the fatigue failures have lately been found to occur well after 107 load cycles, namely in the Very High Cycle Fatigue (VHCF) range. LÄS MER
38. Very high cycle fatigue of tool steels
Sammanfattning : An increasing number of engineering components are expected to have fatigue life in the range of 107 - 1010 load cycles. Some examples of such components are found in airplanes, automobiles and high speed trains. LÄS MER
39. Performance of advanced tool steels for cutting tool bodies
Sammanfattning : Performance of indexable insert cutting tools is not only about the performance of cutting inserts. It is also about the cutting tool body, which has to provide a secure and accurate insert positioning as well as its quick and easy handling under severe working conditions. LÄS MER
40. On tool steel, surface preparation, contact geometry and wear in sheet metal forming
Sammanfattning : In sheet metal forming operations the life length of the production equipment islargely dependent on the wear of the tools that are in direct contact with the sheet.One form of adhesive wear where some sheet material gets transferred to the tool, alsoknown as galling, is the most common cause of tool failure. LÄS MER