Sökning: "Compressor"
Visar resultat 21 - 25 av 117 avhandlingar innehållade ordet Compressor.
21. Design optimisation of aeroengine compressor blades
Sammanfattning : Optimisation of multistage axial compressors is a time-demanding challenge in large need of effective methods. Traditionally, the design has been based on "trial-and-error" procedures, which count on the skills and experience of the designer to suggest redesigns that are likely to yield improvements. LÄS MER
22. Turbocharger Compressor Noise: a Numerical Study
Sammanfattning : Road transport is the primary means of conveyance of passengers and freight in the EU, accounting for 71% and 52% of the totals, respectively. At low speeds and in situations with frequent start-stops and accelerations, i.e. LÄS MER
23. Modelling and Numerical Analysis of the Centrifugal Compressor and its Operation in the Pressurised SOFC GT Process
Sammanfattning : Small-scale power plants based on the SOFC-GT (Solid Oxide Fuel Cell-Gas Turbine) system are foreseen for future application such as APU units in flight transportation systems or stationary power production. Although these new systems offer high load flexibility and potentially high efficiency, there are several constraints referring to thermal/mechanical stress of the fuel cell as well as to a potential risk of aerodynamic instability of the GT compressor due to the different physical behavior of the SOFC and the GT. LÄS MER
24. Aerodynamics of an Aeroengine Intermediate Compressor Duct: Effects from an Integrated Bleed System
Sammanfattning : With the successful development of high-bypass-ratio turbofan engines, major aerodynamic components have been optimized and continuous efficiency improvements are getting harder to maintain. Therefore, to meet the requirements of lower emission of greenhouse gases, auxiliary modules such as intermediate ducts are receiving increasing interest. LÄS MER
25. Analytic Parameterization of Stabilizing Controllers for the Moore-Greitzer Compressor Model
Sammanfattning : This work presents an extension, simplification and application of a design procedure for dynamic output feedback design for systems with nonlinearities satisfying quadratic constraints (QC). Our method was motivated by the challenges of output feedback control design for the three-state Moore-Greitzer (MG) compressor model. LÄS MER