Sökning: "Pressure Drop"

Visar resultat 21 - 25 av 198 avhandlingar innehållade orden Pressure Drop.

  1. 21. Investigation of Some Heat Transfer Surfaces for Gas Turbine Recuperators

    Författare :Esa Utriainen; Värmeöverföring; []
    Nyckelord :TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; trapezoidal; corrugated undulated; cross wavy; cross corrugated; chevron; pressure drop; heat transfer; microturbine; Recuperator; gas turbine; plate-fin; Technological sciences; Teknik; Thermal engineering; applied thermodynamics; Termisk teknik; termodynamik; Gases; fluid dynamics; plasmas; Gaser; fluiddynamik; plasma;

    Sammanfattning : A part of this thesis has been devoted to present general recuperator technology such as available gas turbine recuperator types, applications where recuperators are utilized, recuperator materials etc. An investigation of some compact and highly efficient heat transfer surfaces, for intended use in gas turbine recuperators, include the following surfaces: · Cross Wavy (CW) primary surface. LÄS MER

  3. 22. Heat Transfer and Pressure Drop in a Plate-Type Evaporator

    Författare :Sven Wellsandt; Chalmers tekniska högskola; []
    Nyckelord :TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY;

    Sammanfattning : .... LÄS MER

  4. 23. Flow dynamics of exhaust aftertreatment systems

    Författare :Fredrik Ekström; Chalmers tekniska högskola; []
    Nyckelord :TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; catalytic converter; heat and mass transfer; pressure drop; exhaust; CFD; flow distribution;

    Sammanfattning : .... LÄS MER

  5. 24. Turbulent Forced Convection Air Cooling of Electronics with Heat Sinks Under Flow Bypass Conditions

    Författare :Hans Jonsson; KTH; []
    Nyckelord :forced convection; heat transfer; pressure drop; turbulent; air cooling; bypass; plate; strip; pin; fin; heat sink; electronics; experimental; numerical; CFD; TECHNOLOGY; TEKNIKVETENSKAP;

    Sammanfattning : Air cooling is still the dominant method for dissipating theheat produced by electronic components. In a typical electronicdevice, the components are situated on a Printed Circuit Board(PCB). For most applications natural convection is sufficientto cool the components. LÄS MER

  7. 25. Improvement of the retention-fromation relationship using three-component retention aid systems

    Författare :Anna Svedberg; Lars Wågberg; Janne Laine; KTH; []
    Nyckelord :TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; Dewatering; drag reduction; fibre flocculation; filler retention; fine paper; flow imaging; flow loop; formation aid; kraft pulp; magnetic resonance imaging; MRI; paper formation; pilot web former; pressure drop; retention aid; turbulence damping;

    Sammanfattning : .... LÄS MER