Sökning: "neutrondiffraktion"
Hittade 5 avhandlingar innehållade ordet neutrondiffraktion.
1. Pressure-Induced Amorphization and Distinct Amorphous States of Clathrate Hydrates
Sammanfattning : This thesis summarizes a study on the pressure-induced amorphization (PIA) and structures of amorphous states of clathrate hydrates (CHs).PIA involves the transition of a crystalline material into an amorphous solid in response of mechanical compression at temperatures well below the melting point. LÄS MER
2. Microstructure and mechanical properties of low-temperature hot isostatic pressed Ti-6Al-4V manufactured by electron beam melting
Sammanfattning : Ti-6Al-4V manufactured by electron beam melting Keywords: Additive manufacturing, high-temperature tensile properties, low cycle fatigue, neutron diffraction, fatigue crack growth ISBN: 978-91-89325-27-2 (Printed) 978-91-89325-26-5 (Electronic) Ti-6Al-4V is the most widely used α+β titanium alloy in aerospace engine applications due to its high specific strength. Typically, the alloy is manufactured as castings or forgings and then machined to final geometry. LÄS MER
3. Simulation of robot paths and heat effects in welding
Sammanfattning : The objective of this thesis is to develop a simulation tool and a method by which robot trajectories, temperature histories, residual stresses and distortion can be analysed and optimized off-line. This was performed by integrating robot simulation software with finite element analysis software. LÄS MER
4. Neutron scattering studies of hard metals
Sammanfattning : Since their discovery about 100 years ago, tools made of hard metals have been the enablers of development in various areas: from drilling subway lines for more sustainable cities to the machining of complex next-generation airplane engine parts for reduced CO2 emissions. An increase in properties of hard metals thus leads to efficient operations with shorter lead-time, less environmental footprint, and reduced cost. LÄS MER
5. Anisotropic mechanical behaviors and microstructural evolution of thin-walled additively manufactured metals
Sammanfattning : Additive manufacturing (AM), also known as 3D printing, is a concept and method of a manufacturing process that builds a three-dimensional object layer-by-layer. Opposite to the conventional subtractive manufacturing, it conquers various limitations on component design freedom and raises interest in various fields, including aerospace, automotive and medical applications. LÄS MER