Sökning: "low modulus"
Visar resultat 21 - 25 av 183 avhandlingar innehållade orden low modulus.
21. Nanomechanical Studies and Applications of Cantilever Sensors
Sammanfattning : Different aspects of cantilevers to be used as sensors have been studied. Silicon cantilevers have been fabricated and integrated on CMOS chips using low-energy electron beam lithography in order to reduce the irradiation damage to the circuits. The released and integrated cantilevers have been tested and used as mass sensors in air. LÄS MER
22. Mechanical properties of carbon nanotubes and nanofibers
Sammanfattning : Carbon nanotubes (CNTs) have extraordinary electrical and mechanical properties, and many potential applications have been proposed, ranging from nanoscale devices to reinforcement of macroscopic structures. However, due to their small sizes, characterization of their mechanical properties and deformation behaviours are major challenges. LÄS MER
23. Fabrication and Characterization of Zinc Oxide Nanostructures for Piezoelectric, Mechanical and Electrical Applications
Sammanfattning : Nanotechnology, the science of manipulating materials on an atomic or molecular scale is one of the fastest growing areas of research and technology. Nanotechnology has a vast range of applications in medicine, electronics, biomaterials and energy production. New developments in nanotechnology are growing all the time. LÄS MER
24. Dynamic properties of two pedestrian timber bridges : Experimental and numerical analysis at several stages of construction
Sammanfattning : Pedestrian bridges can beneficially be made from timber in order for our society to reach a sustainable future. This positive development is partly made possible due to advances in engineered wood products (e.g. glued laminated timber) and the possibilities for pre-fabrication of structural parts. LÄS MER
25. Mechanical behaviour of a roller bearing steel : Strength differential effect, low temperature creep and propagation of short cracks
Sammanfattning : Fatigue cracks in bearings either initiate from the surface or from an inclusion below the rolling contact surface. Then, short cracks start to propagate. Short crack grow at considerably faster rates than long cracks subjected to a nominally equivalent stress intensity factor range. LÄS MER