Sökning: "grain size analysis"
Visar resultat 1 - 5 av 99 avhandlingar innehållade orden grain size analysis.
1. WC grain growth during sintering of cemented carbides : Experiments and simulations
Sammanfattning : Cemented carbides are composite materials consisting of a hard carbide and a ductile binder. They are powdermetallurgically manufactured, where liquid-phase sintering is one of the main steps. The most common cemented carbide consists of WC and Co and it is widely used for cutting tools. LÄS MER
2. Inclusions and/or Particles Engineering for Grain Refining Purposes in Ferritic Fe-20mass%Cr alloys
Sammanfattning : Compared to more common used austenitic stainless steels, ferritic stainless steels contain very low amounts of the expensive alloying element Ni. In addition, they have good corrosion properties, but are sometimes suffering from poor weldability and bad mechanical properties. LÄS MER
3. On Peritectic Reactions and Transformations and Hot Forming of Cast Structures
Sammanfattning : This thesis deals with peritectic reactions and transformations that occur during the solidification of many alloys. Peritectics are believed to be a major cause of crack-formation in many steels, thus, good knowledge of the mechanisms by which these phenomena occur is essential for preventing such defects. LÄS MER
4. The mechanisms of metal expansion penetration during solidification of grey cast iron
Sammanfattning : The production of high quality castings requires the casting surface to be clean and free from defects. One type of defect often found is caused by metal penetration into the sand mould. LÄS MER
5. Physical properties of coarse particles in till coupled to bedrock composition based on new 3D image analysis method
Sammanfattning : The physical properties of the coarse fraction of the till (0.4 to 20 cm) and the surface boulders have been studied at two different sites in Sweden. LÄS MER