Sökning: "cracks"

Visar resultat 1 - 5 av 468 avhandlingar innehållade ordet cracks.

  1. 1. Wheel/rail wear and surface cracks

    Författare :Rickard Nilsson; KTH; []
    Nyckelord :wheel; rail. Profile; surfaces; hardness; wear; cracks;

    Sammanfattning : .... LÄS MER

  3. 2. Modelling and simulation of short fatigue cracks

    Författare :Christina Bjerkén; Materialteknik; []
    Nyckelord :TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; materialteknik; Materiallära; Material technology; Interface cracks; Dislocations; Short cracks; Local plasticity;

    Sammanfattning : The growth of short fatigue cracks deviates from the behaviour of long fatigue cracks even if subjected to the same nominal driving force. The influence from the microstructure is pronounced, while crack closure effects may not be that important as for longer cracks. LÄS MER

  4. 3. Cracks in superalloys

    Författare :Jonas Saarimäki; Johan Moverare; Kjell Simonsson; Magnus Hörnqvist Colliander; Robert Eriksson; Håkan Brodin; Mark Whitaker; Linköpings universitet; []
    Nyckelord :TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY;

    Sammanfattning : Gas turbines are widely used in industry for power generation and as a power source at hard to reach locations where other possibilities for electrical power supplies are insufficient. New ways of producing greener energy is needed to reduce emission levels. This can be achieved by increasing the combustion temperature of gas turbines. LÄS MER

  5. 4. Assessment of Concrete Structures Including Corrosion and Cracks

    Författare :Mattias Blomfors; Chalmers tekniska högskola; []
    Nyckelord :TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; reinforced concrete; corrosion; nonlinear FE analysis; reinforcement bond; assessment; cracks;

    Sammanfattning : Reinforced concrete (RC) structures constitute a major proportion of the built environment and society relies continuously on their service. Many of these structures were built in the era following the Second World War and are thus approaching the end of their intended service life. LÄS MER

  7. 5. Adhesion to machined and laser ablated wood surfaces

    Författare :Micael Stehr; KTH; []
    Nyckelord :LANTBRUKSVETENSKAPER; AGRICULTURAL SCIENCES; ablation; adhesion; checks; coating; cracks; excimer laser; gluing; IR laser; mechanical machining; mechanical weak boundary layer; microscopy; notched specimens; pine; planing; sample preparation; sawing; scanning electronmicroscopy; spruce; tip-cracks; UV laser; weak boundary layer; wood;

    Sammanfattning : This thesis is a contribution to the R&D-program ValueActivation at KTH,Division of Wood Technology and Processingand containsfive papers related to the evaluation and development ofmachining techniques (mechanical and irradiation treatments)whereby weak boundaries at the wood surfaces in the form of(mechanical) weak boundary layers and (micro) cracks due tomechanical treatment can be avoided.The first paper describes the development of a method–using a UV laser–to study the mechanically weakenedboundaries. LÄS MER