Sökning: "casting"
Visar resultat 21 - 25 av 306 avhandlingar innehållade ordet casting.
21. An Experimental Study to Improve the Casting Performance of Steel Grades Sensitive for Clogging
Sammanfattning : In this study, the goal is to optimize the process and to reduce the clogging tendency during the continuous casting process. The focus is on clogging when the refractory base material (RBM) in the SEN is in contact with the liquid steel. LÄS MER
22. On Tool Failure in Die Casting
Sammanfattning : Die casting is a very cost-efficient method of forming thin-walled and complex near net-shaped products with close geometric tolerances and good surface finish. A permanent die tool is used to make large quantities of identical products. The performance and tool life are limited by several mechanisms, e.g. LÄS MER
23. Casting for Knowledge and Landing Understanding : Exploring the management of Swedish recreational fisheries as social-ecological systems
Sammanfattning : The successful management of recreational fisheries must balance ecological, and social goals; select from and implement a range of management tools; operate under often complex governance structures; and contend with diverse human stakeholders’ expectations, desires, and actual behaviour in response to management activities. This complexity also means that there are many knowledge and research gaps regarding the information needed to meet the requirements of specific fisheries. LÄS MER
24. Heat transfer phenomena and mould flux lubrication in continuous casting of steel
Sammanfattning : Overall thermal resistance of the mould flux was measured tomake clear the influence of the mould flux properties on theheat transfer behavior in continuous casting, especiallythermal conductivity and the formation of air gaps in thisstudy. From the investigation of the effect of the mouldsurface temperature and physical properties of the mould fluxon heat transfer through the flux film, following knowledge hasbeen obtained. LÄS MER
25. Casting and anodising of Al alloys- Alloy design, manufacturing process and material properties
Sammanfattning : Casting and semi-solid metal (SSM) casting are widely used to manufacture near-net-shape components of Al-Si alloys in the automotive and electronic industries. In such applications, casting components need to meet the combined requirements of good mechanical properties and corrosion and wear resistance. LÄS MER