Sökning: "Grouting"

Visar resultat 1 - 5 av 39 avhandlingar innehållade ordet Grouting.

  1. 1. Rheology of cement grout  : Ultrasound based in-line measurement technique and grouting design parameters

    Författare :Mashuqur Rahman; Stefan Larsson; Ulf Håkansson; Olafur Wallevik; KTH; []
    Nyckelord :ENGINEERING AND TECHNOLOGY; TEKNIK OCH TEKNOLOGIER; TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; grouting; grouting design; cement grout; Bingham number; shear rate; plug flow; thixotropy; yield stress; in-line rheology; UVP PD; Flow-Viz; viscosity bifurcation; aging; off-line rheometry; pump characteristics; Civil and Architectural Engineering; Byggvetenskap;

    Sammanfattning : Grouting is performed in order to decrease the permeability and increase the stiffness of the material, especially soil and rock. For tunnelling and underground constructions, permeation grouting is done where cement based materials are pumped inside drilled boreholes under a constant pressure, higher than the ground water pressure. LÄS MER

  2. 2. Grouting of Fractured Rock with Silica Sol; Grouting design based on penetration length

    Författare :Johan Funehag; Chalmers University of Technology; []
    Nyckelord :TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; Grouting; hydraulic test; sand column; propagation; penetration length; pipe flow; aperture; transmissivity; colloidal silica; silica sol; rheology; gelling liquids; field study;

    Sammanfattning : ABSTRACTRecent grouting projects in Sweden have concentrated on the grout itself. The only grout normally used in Sweden is cement-based. During the past 10 years, the acceptable flow of water into tunnels has been reduced significantly. The current requirements mean that an average fracture aperture of around 0. LÄS MER

  3. 3. Characterisation of Fractured Rock for Grouting Using Hydrogeological Methods

    Författare :Åsa Fransson; Chalmers University of Technology; []
    Nyckelord :hydraulic test; specific capacity; grouting; water pressure test; geological mapping; grout take; aperture; penetration length; transmissivity;

    Sammanfattning : Sealing of tunnels by grouting demands knowledge concerning the fractured rock and the grout, followed by an appropriate choice of strategy and equipment. In this thesis, the characterisation of rock is the main issue and, since it addresses the engineering problem of producing a description for grouting, the properties of grout and the grouting procedure need to be considered. LÄS MER

  4. 4. Design approaches for grouting of rock fractures; Theory and practice

    Författare :Jalaleddin Yaghoobi Rafi; Stefan Larsson; Håkan Stille; Thomas Dalmalm; Lars Ericsson; KTH; []
    Nyckelord :ENGINEERING AND TECHNOLOGY; TEKNIK OCH TEKNOLOGIER; TEKNIK OCH TEKNOLOGIER; ENGINEERING AND TECHNOLOGY; Grouting; Rock mechanics; Jacking; penetration length; Järnvägsgruppen - Infrastruktur; Järnvägsgruppen - Infrastruktur;

    Sammanfattning : Currently, cement base grout is used widely for sealing of the rock fractures in order to decrease the permeability of rock mass. Grouting procedure is one of the main tasks in cycle of rock excavation. In addition, huge amount of grout should be used during dam construction in order to seal the bedding and embankment walls. LÄS MER

  5. 5. On the Use of Engineering Geological Information in Rock Grouting Design

    Författare :Sara Kvartsberg; Chalmers University of Technology; []
    Nyckelord :Observational method; Transmissivity distribution; Grouting; Design class; Geological prognosis; Fractured rock; Hydraulic domain; Tunnels;

    Sammanfattning : Underground rock construction is dependent on appropriate assessments of the geological settings at the project site. Relevant geological information must be collected, interpreted and communicated clearly with the aid of engineering geological prognoses. LÄS MER