Sökning: "Common rail"
Visar resultat 1 - 5 av 38 avhandlingar innehållade orden Common rail.
1. Degradation of railway rails from a materials point of view
Sammanfattning : From time to time railway rails need to be replaced. In that case and when new track is built, a decision has to be made about which rail grade that is going to be installed. The intention of this work was to compare different rail steels concerning their suitability from a mechanical durability perspective. LÄS MER
2. A Combustion Concept for Future Heavy-Duty Diesel Engines
Sammanfattning : The Diesel engine has been intensively developed by manufacturers and researchers since 1892, when it was invented. However, the direction of its development has shifted in recent years.Environmental issues are becoming increasingly important in our society, prompting more efforts to be put into making the engines cleaner. LÄS MER
3. Comparability of Railway Rail Steels Low Cycle Fatigue Behaviour
Sammanfattning : Several different kinds of steel are used for railway rails. From simple pearlitic steels for rarely used tracks over premium pearlitic steels for high performance lines to special bainitic, martensitic and austenitic steels for switches and crossings. Most of these steels have been trial and error developed over time in track. LÄS MER
4. Surface defects in rails - Potential influence of operational parameters on squat initiation
Sammanfattning : Despite significant efforts throughout the last decades, the mechanisms behind the formation of squats — a form of rolling contact fatigue (RCF) damage in rails — are not fully understood. Proposed causes of initiation involve, but are not limited to, small initial rail surface irregularities which yield high contact stresses, rail corrugation and varying friction conditions. LÄS MER
5. Wear reduction performance of rail flange lubrication
Sammanfattning : Rail and rail wheel flange wear on the rail track has been a problem of attention for the last 30 years. The problems arise in curves and depend on increased traffic volume, heavier axle load and also higher speed. Axle loads of 22,5-25 ton is common nowadays and the trend is towards heavier axle loads where the next step is 30-35 ton. LÄS MER