Experimental analysis of thermal mixing at reactor conditions

Sammanfattning: High-cycle thermal fatigue arising from turbulent mixing of non-isothermal flows is a key issue associated with the life management and extension of nuclear power plants. The induced thermal loads and damage are not fully understood yet.With the aim of acquiring extensive data sets for the validation of codes modeling thermal mixing at reactor conditions, thermocouples recorded temperature time series at the inner surface of a vertical annular volume where turbulent mixing occurred. There, a stream at either 333 K or 423 K flowed upwards and mixed with two streams at 549 K. Pressure was set at 72E5 Pa. The annular volume was formed between two coaxial stainless-steel tubes. Since the thermocouples could only cover limited areas of the mixing region, the inner tube to which they were soldered was lifted, lowered, and rotated around its axis, to extend the measurement region both axially and azimuthally.Trends, which stemmed from the variation of the experimental boundary conditions over time, were subtracted from the inner-surface temperature time series collected. An estimator assessing intensity and inhomogeneity of the mixing process in the annulus was also computed. In addition, a frequency analysis of the detrended inner-surface temperature time series was performed. In the cases examined, frequencies between 0.03 Hz and 0.10 Hz were detected in the subregion where mixing inhomogeneity peaked.The uncertainty affecting such measurements was then estimated.Furthermore, a preliminary assessment of the radial heat flux at the inner surface was conducted.