Multi-Gigabaud Solutions for Millimeter-wave Communication

Sammanfattning: With the growing number of mobile network and internet services subscriptions, faster communication will provide a better experience for users. In the next generation mobile network, the fifth generation (5G), communication data rate will achieve several Gigabits per second with ultra-low latency. The capacity enhancement of the mobile backhaul and fronthaul is a challenge. The transmission capacity can be enhanced by increasing the bandwidth, increasing the spectrum efficiency and increasing both the bandwidth and the spectrum efficiency at the same time.   Millimeter-wave frequency bands have the bandwidth in the order of GHz which provide great opportunities to realize high data rate communications. In this case, millimeter-wave frontend modules and wideband modems are needed in communication systems. In this thesis, a 40 Gbps real-time differential quadrature phase shift keying (DQPSK) modem has been presented to support high-speed communications [A]. As a complete system, it aims to work together with the D-band frontend module published in [1] providing more than 40 GHz bandwidth. In this modem, the modulator is realized in a single field programmable gate array (FPGA) and the demodulator is based on analog components. Although millimeter-wave frequency bands could provide wide available bandwidth, it is challenging to generate high output power of the carrier signal. In addition, the transmitter needs to back off several dB in output power in order to avoid the non-linear distortion caused by power amplifiers. In this thesis, an outphasing power combining transmitter is proposed [B] to use the maximum output power of power amplifiers while maintaining the signal quality at the same time. This transmitter is demonstrated at E-band with commercially available components. Increasing the spectrum efficiency is an additional method to enhance the transmission capacity. High order modulation signals such as quadrature amplitude modulation (QAM) signals are commonly used for this purpose.  In this case, receivers usually require coherent detection in order to demodulate the signals. Limited by the sampling rate of the analog to digital converters (ADCs), the traditional digital carrier recovery methods can be only applied to a symbol rate lower than the sampling rate. A synchronous baseband receiver is proposed [C] with a carrier recovery subsystem which only requires a low-speed ADC with a sampling rate of 100 MSps.