Microbial Fuel cells, applications and biofilm characterization

Sammanfattning: Since the 1900’s it has been known that microorganisms are capable of generating electrical power through extracellular electron transfer by converting the energy found organic compounds (Potter, 1911). Microbial fuel cells (MFCs) has garnered more attention recently, and have shown promise in several applications, including wastewater treatment (Yakar et al., 2018), bioremediation (Rosenbaum & Franks, 2014), biosensors (ElMekawy et al., 2018) desalination (Zhang et al., 2018) and as an alternative renewable energy source in remote areas (Castro et al., 2014). In MFCs catalytic reactions of microorganisms oxidize an electron donor through extracellular electron transfer to the anode, under anaerobic conditions, with the cathode exposed to an electron acceptor, facilitating an electrical current (Zhuwei, Haoran & Tingyue, 2007; Lovley, 2006). For energy production in remote areas a low cost and easily accessible feed stock is required for the MFCs. Sweet sorghum is a drought tolerant feedstock with high biomass and sugar yields, good water-use efficiency, established production systems and the potential for genetic improvements. Because of these advantages sweet sorghum stalks were proposed as an attractive feedstock (Rooney et al., 2010; Matsakas & Christakopoulos, 2013). Dried sweet sorghum stalks were, therefore, tested as a raw material for power generation in a MFC, with anaerobic sludge from a biogas plant as inoculum (Sjöblom et al., 2017a).Using sorghum stalks the maximum voltage obtained was 546±10 mV, the maximum power and current density of 131±8 mW/m2 and 543±29 mA/m2 respectively and the coulombic efficiency was 2.2±0.5%. The Ohmic resistances were dominant, at an internal resistance of 182±17 Ω, calculated from polarization data. Furthermore, hydrolysis of the dried sorghum stalks did not improve the performance of the MFC but slightly increased the total energy per gram of substrate. During the MFC operation, the sugars were quickly fermented to formate, acetate, butyrate, lactate and propionate with acetate and butyrate being the key acids during electricity generation.Efficient electron transfer between the microorganisms and the electrodes is an essential aspect of bio-electrochemical systems such as microbial fuel cells. In order to design more efficient reactors and to modify microorganisms, for enhanced electricity production, understanding the mechanisms and dynamics of the electron transport chain is important. It has been found that outer membrane C-type cytochromes (OMCs) (including omcS and omcZ discussed in this study) play a key role in the electron transport chain of Geobacter sulfurreducens, a well-known, biofilm forming, electro-active microorganism  (Millo et al., 2011; Lovley, 2008). It was found that Raman microscopy is capable of providing biochemical information, i.e., the redox state of c-type cytochromes (cyt-C) without damaging the microbial biofilm, allowing for in-situ observation.Raman microscopy was used to observe the oxidation state of OMCs in a suspended culture, as well as in a biofilm of an MFC. First, the oxidation state of the OMCs of suspended cultures from three G. sulfurreducens strains (PCA, KN400 and ΔpilA) was analyzed. It was found that the oxidation state can also be used as an indicator of the metabolic state of the cells, and it was confirmed that PilA, a structural pilin protein essential for long range electron transfer, is not required for external electron transfer. Furthermore, we designed a continuous, anaerobic MFC enabling in-situ Raman measurements of G. sulfurreducens biofilms during electricity generation, while poised using a potentiostat, in order to monitor and characterize the biofilm. Two strains were used, a wild strain, PCA, and a mutant, ΔOmcS. The cytochrome redox state, observed through the Raman spectra, could be altered by applying different poise voltages to the electrodes. This change was indirectly proportional to the modulation of current transferred from the cytochromes to the electrode. This change in Raman peak area was reproducible and reversible, indicating that the system could be used, in-situ, to analyze the oxidation state of proteins responsible for the electron transfer process and the kinetics thereof.