Sökning: "Angle-resolved time-of-flight"
Hittade 5 avhandlingar innehållade orden Angle-resolved time-of-flight.
1. Constructing and Commissioning HELIOS – A High Harmonic Generation Source for Pump-Probe Measurements with sub 50 fs Temporal Resolution : The Development of Experimental Equipment for Extreme Ultraviolet Spectroscopy
Sammanfattning : This thesis presents HELIOS, an in-house laboratory for time-resolved pump-probe spectroscopy with extreme-ultraviolet (XUV) probe radiation. A wide span of pump wavelengths can be generated using commercial laser equipment while XUV probe radiation is generated via a high harmonic generation process in a noble gas delivering probe photons with energies between 20 eV and 72 eV. LÄS MER
2. On the Challenges for Time-of-Flight Electron Spectroscopy at Storage Rings
Sammanfattning : Time-of-flight (TOF) techniques for energy analysis have been common in electron spectroscopy for many decades. TOF-based electron spectrometers benefit from higher transmission and information rate compared to their main competitor: the hemispherical analyser; the drawback being their lower energy resolution. LÄS MER
3. Angle-resolved photoemission study of unconventional cuprate superconductors
Sammanfattning : Understanding unconventional superconductivity remains one of the most important unsolved problems in physics. A particularly noteworthy case is the copper-based high-temperature superconductor, which stands out due to its remarkably high transition temperature and relatively simple structure. LÄS MER
4. Consequences of a non-trivial band-structure topology in solids : Investigations of topological surface and interface states
Sammanfattning : The development and characterization of experimental setups for angle-resolved photoelectron spectroscopy (ARPES) and spin- and angle-resolved photoelectron spectroscopy (SARPES) is described. Subsequently, the two techniques are applied to studies of the electronic band structure in topologically non-trivial materials. LÄS MER
5. Surface Interactions in Powder Injection Moulding
Sammanfattning : Powder Injection Moulding (PIM) is an attractive technique for producing complex components in large quantities my means of powder technology. The process includes mixing powder with a suitable binder, usually a thermoplastic polymer. Because of the large attractive forces between small particles the powder can be agglomerated in the binder. LÄS MER