Sökning: "Al-Si alloys"
Visar resultat 1 - 5 av 18 avhandlingar innehållade orden Al-Si alloys.
1. On the influence of imperfections on microstructure and properties of recycled Al-Si casting alloys
Sammanfattning : There are great energy savings to be made by recycling aluminium; as little as 5% of the energy needed for primary aluminium production may be required. Striving to produce high quality aluminium castings requires knowledge of microstructural imperfections, which is extra important when casting recycled aluminium that generally contains higher levels of imperfections compared to primary aluminium. LÄS MER
2. Investigations on the Formation of Defect Bands in Semi-Solid High Pressure Die Cast Aluminium-Silicon Alloys
Sammanfattning : High-pressure die casting of semi-solid aluminium-silicon alloys is used in the automotive industry to manufacture components, like housings, brackets, and bars. It is commonly known that during high-pressure die casting, defect bands may be created that follow the contour of the component surface. These bands consist mainly of a eutectic phase. LÄS MER
3. Eutectic Modification of Al-Si casting alloys
Sammanfattning : Aluminum alloys with silicon as the major alloying element are the most widely used aluminum casting alloys. The eutectic phase in these alloys is formed by hard and brittle silicon plates in an aluminum matrix. Such silicon plates can act as crack propagation paths deteriorating the toughness of the material. LÄS MER
4. Heat treatment of Al-Si-Cu-Mg casting alloys
Sammanfattning : Environmental savings can be made by increasing the use of aluminium alloys in the automotive industry as the vehicles can be made lighter. Increasing the knowledge about the heat treatment process is one task in the direction towards this goal. The aim of this work is to investigate and model the heat treatment process for Al-Si casting alloys. LÄS MER
5. An Insight into the Critical Role of Microstructure and Surface Preparation on Localized Conversion Coating Deposition on Cast Al Alloys
Sammanfattning : The spontaneous cerium conversion coating formation over aluminium alloys is affected by the chemical process conditions, the surface preparation prior to conversion treatment and the microstructure of the underlying alloy. Most research performed until now focus only on the former whereas the influence of the latter two is poorly understood. LÄS MER