On millimeter and submillimeter wave focal plane arrays implemented with MEMS waveguide switches

Sammanfattning: This thesis presents research towards enabling micromachined millimeter and submillimeter wave focal plane arrays (FPAs). The FPAs operate under the following principle: a switch network consisting of microelectromechanical (MEMS) switches, integrated with micromachined waveguides, is used to feed an array of antenna elements, located in the focal plane of a high-gain quasi-optical system. Hence, it is possible to switch between a set of narrow beams in different directions. Such beam steering systems are needed for future millimeter and submillimeter wave imaging and communication systems. The contributions to future MEMS-switchable FPAs presented here are organized in three papers, as described below.Paper I presents a criterion on the spacing between adjacent FPA elements which results in -3 dB overlap between the switched beams, for the special case when an extended hemispherical dielectric lens is used as the optical system. A key step towards this criterion is a closed-form relation between the scan angle and the FPA element's position, which results in an expression for the effective focal length of extended hemispherical lenses. A comparison with full-wave simulations demonstrates an excellent agreement with the presented theoretical results. Finally, it is shown that the maximum feasible FPA spacing when using an extended hemispherical lens is about 0.7 wavelengths.Paper II presents a numerical study of silicon-micromachined planar extended hemispherical lenses, with up to three matching regions used to reduce internal reflections. The effective permittivity of the matching regions is tailor-made by etching periodic holes in the silicon wafer. The optimal thickness and permittivity of the matching regions were determined using TRF optimization, in order to yield the maximum wide-band aperture efficiency and small side-lobes. We introduce a new matching region geometry, referred to as shifted-type matching regions, and it is demonstrated that using three shifted-type matching regions results in twice as large aperture efficiency as compared to using three conventional concentric-type matching regions.Paper III presents a submillimeter-wave single-pole single-throw (SPST) 500-750 GHz MEMS waveguide switch, based on a MEMS-reconfigurable surface inserted between two waveguide flanges. A detailed design parameter study is carried out to select the best combination of the number of horizontal bars and vertical columns of the MEMS-reconfigurable surface, for achieving a low insertion loss in the transmissive state and a high isolation in the blocking state. A method is presented to model the non-ideal electrical contacts between the vertical cantilevers of the MEMS surface, with an excellent agreement between the simulated and measured isolation. It is shown that the isolation can be improved by replacing an ohmic contact by a new, capacitive contact. The measured isolation of the switch prototype is better than 19 dB and the measured insertion loss is between 2.5 and 3 dB.